Connect The Controlling And Expansion Chassis; Figure 3-19 19" Expansion Chassis Interface Units; Figure 3-20 System Expansion Cabling - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

Connect the Controlling and Expansion Chassis

Expansion Chassis Interface Unit

for the Expansion Chassis

Expansion Chassis Interface Unit

for the Controlling Chassis

Installment of the PZ-BS10 blade and PZ-BS11 blade(s) must

be completed prior to installation of the provided (CAT 5)

expansion cabling.

Ensure Controlling and Expansion chassis are

powered down.

Using the NEC provided CAT5 straight-through

cable(s), attach one end to each Expansion Chassis

CN2 connector on the PZ-BS11 blade (see

3-20 System Expansion Cabling on page

Attach the opposite end to the CN2, CN3 or CN4

connector on the PZ-BS10 of the Controlling