Figure 5-30 Attaching Directory Card To Directory Card Holder; Installing The Directory Card On The Multiline Terminal - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
4.6
5 - 36

Installing the Directory Card on the Multiline Terminal

A directory card can be attached to DT300/DT700 Series multiline terminals.
The directory card can be used to record often dialed numbers or other
important information.
1. After recording the information on the lined insert, reinsert it between the
plastic panels of the directory card. Attach the directory card to the
directory card holder as illustrated in
Card to Directory Card
card holder.
Directory Card

Figure 5-30 Attaching Directory Card to Directory Card Holder

2. Locate the two grooves on the top of the telephone as illustrated in
Figure 5-31 Attaching Directory Card Holder to the Multiline
Push the directory card holder into the grooves on the multiline terminal
until they snap into place.

To remove the directory card, press the two sides of the directory card holder
inward until the tabs release and pull the holder out of the grooves.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Figure 5-30 Attaching Directory
Holder. The open end slides into the directory
UNIVERGE SV8100
Directory Card
Holder
Terminal.