NEC Univerge SV8100 System Hardware Manual page 464

Hide thumbs Also See for Univerge SV8100:

Table of Contents

Technology and is connected in tandem to a multiline terminal. The terminal has a

16-digit, 2-line LCD, dial pad, talk key, chan key, hold key, transfer key, conf key,

mute key, vol key, a msg icon, vibrator, and four function keys with red LEDs.

In an ideal state, this terminal can be switched between cordless and the multiline

terminal connected to it using Cordless or Desk key on the base unit.

Connect the telephone line cord to the TEL LINE jack and the other end

to the AP(R)-L Unit. Refer to paragraph

for detailed instructions for installing the AP(R)-L Unit. This unit can also

be connected using an SLI(4)/(8)-U( ) ETU.

AP(R)-L Unit

Figure 6-3 Connecting the D

to the AP(R)-L Unit

Place the power cord so that it does not create a trip hazard or where it

could become chafed and create a fire or electrical hazard.

Observe the following warnings during installation:

Never install telephone wiring during a lightning storm.

Never touch uninsulated telephone wires or terminals unless the

telephone line is disconnected at the network interface.

Use caution when installing or modifying telephone lines.

Cordless II terminal uses 900MHz Digital Spread Spectrum (DSS)

Telephone Line Cord

Headset Cordless Telephone Cord

Installing SV8100 Cordless Telephones

UNIVERGE SV8100

12.4 APR-L UNIT on page 9-77