Connector Pin-Out On The Pz-Bs10/Pz-Bs11; Install The Pz-Bs10 Expansion Base Blade In The Chs2U-Us Controlling Chassis; Figure 3-6 Pz-Bs10 Expansion Bay In Controlling Chassis; Table 3-3 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
3 - 10
3.3.2.1

Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 3-3 PZ-BS10/PZ-BS11 Connector Pin-Out

PZ-BS10 – CN2, CN3, CN 4
3.3.2.2 Install the PZ-BS10 Expansion Base Blade in the
CHS2U-US Controlling Chassis
1. Ensure the chassis is powered down.
2. Locate the door positioned on the left end
(expansion bay) of the Controlling Chassis.

Figure 3-6 PZ-BS10 Expansion Bay in Controlling Chassis

RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Expansion Bay
Installing the SV8100 Chassis
UNIVERGE SV8100
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)