Install Ac Power Cord On 9.5" Base And Expansion Chassis; Install Ac Power Cord On Multiple 9.5" Base And Expansion Chassis; Install Additional Blades In The 9.5" Base And Expansion Chassis; Figure 3-47 9.5" Base Chassis (Rear View) - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
W
S 4
ALL
ECTION
4.1
System Hardware Manual
2. Ground each chassis [refer to
(Rear View) on page
the FG lug on the back side of the chassis to an electrical
service ground (such as a cold water pipe).
3.5.5

Install AC Power Cord on 9.5" Base and Expansion Chassis

Locate the supplied AC power cord and attach to the AC Inlet located
on the back of the chassis [refer to
(Rear View) on page
The CHS2U E (9.5" expansion chassis) does not have an AC Inlet.

3.5.6

Install AC Power Cord on Multiple 9.5" Base and Expansion Chassis

Locate the supplied AC power cords and attach to the AC Inlets
located on the back of the Controlling and Expansion Chassis.
The CHS2U E (9.5" expansion chassis) does not have an AC Inlet.

3.5.7

Install Additional Blades in the 9.5" Base and Expansion Chassis

Refer to Chapter
4-4.
3.5.8 Applying Power to the 9.5" Base and Expansion Chassis
Refer to Chapter
4-9.
M
OUNTING THE
Wall Mounting the 19" (CHS2U-US) Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis (55 lbs per system chassis – including blades, cords, power supply,
etc.). The chassis is secured to the wall with a wall mount bracket. Ensure
that enough space is available to allow the installation of additional expansion
chassis.
4.1.1 CHS2U-US Chassis Wall Mount Installation
1. Use the template shown in
Guide (19" Chassis) on page 3-40
drilling.
3-38] by connecting a 14 AWG wire from
3-38].
4, 2.1 Installation and Safety Precautions on page
4, 2.6 Powering Up the SV8100 System on page
C
HASSIS
Figure 3-48 Wall Mount Spacing
Figure 3-47 9.5" Base Chassis
Figure 3-47 9.5" Base Chassis
for required spacing before
Issue 2.0
3 - 39