Table 4-5 Cd-Cp00-Us Switch Settings - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
2. Refer to
Installed on page 4-17
and/or PZ-32IPLA/PZ-64IPLA/PZ-128IPLA daughter board, if
required.
3. Ensure the power supply is OFF, then slide the CD-CP00-US
into Slot 1 in the Controlling Chassis.
4. If external Background Music (BGM) or Music on Hold (MOH)
is being installed, plug the cable into the CN8 or CN9 pin jack
connector on the CD-CP00-US. The other end of the cable
plugs into the music source.



3.1.3 Switch Settings
Refer to

Table 4-5 CD-CP00-US Switch Settings

system reset and with system power on.
Blade Layout on page 4-16
the CD-CP00-US blade.
Table 4-5 CD-CP00-US Switch Settings
USB Memory Status
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Switch
SW1 – Load
When USB Memory is
Switch
installed:
When an unauthorized USB
device is installed:
Figure 4-7 CD-CP00-US Blade with Daughter Boards
to Install the PZ-VM21, PZ-ME50-US
Refer to the PGD(2)-U10 ADP in the
SV8100 Optional Equipment
ADP on page 9-1 for details on connecting to a music source.
When the system software is upgraded, the flash memory is
updated with the new software version. Either the Hot or Cold
start-up method can be used or the system can be upgraded
using system software. Refer to
on page 4-9, 2.6.2 Performing a Hot Start on page
2.6.4 Performing a Software Upgrade on page
Customer information is stored in the RAM memory which is
restored after a power failure is cleared. The lithium battery in
the system saves the RAM memory when power is lost.
shows the location of the SW1 switch on
Chapter 9 Installing
section 2.1 Using a PGD(2)-U10
2.6.1 Performing a Cold Start
4-14.
for system restart/
Figure 4-6 CD-CP00-US
Operation
Cold Start occurs.

Database default occurs
USB Memory contents loaded.
System does not start and an Illegal
USB device is connected alarm is
recorded.
Issue 2.0
4-10, or
4 - 21