Figure 6-33 Standard Wall Plate Mounting; Mount The Base Unit On A Direct Wall Mounting - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
5.5
6 - 28
4. Slide the wall mount adapter into the notches on the base. Refer to
Figure 6-32 Install the Wall Mount Adapter on page
5. Plug the AC adapter into a standard 120V AC wall outlet. Hook the cord
on the notch of the wall mount adapter. Refer to
Wall Mount Adapter on page
6. Plug the telephone line cord into the telephone outlet. Hook the cord on
the notch of the wall mount adapter.
7. Align the mounting slots on the base with the mounting posts on the wall.
Then push in and down until the telephone is firmly seated. Refer to
Figure 6-33 Standard Wall Plate
DO NOT use an AC outlet controlled by a wall switch.

Mount the Base Unit on a Direct Wall Mounting

If you do not have a standard wall plate, you can mount your phone directly to
the wall. Before doing this, consider the following:
 Avoid electrical cables, pipes, or other items behind the mounting location
that could cause a hazard when inserting screws into the wall.
 Try to mount your telephone within five feet of a working phone jack to avoid
excessive lengths.
6-27.

Figure 6-33 Standard Wall Plate Mounting

Mounting.
Installing SV8100 Cordless Telephones
UNIVERGE SV8100
6-27.
Figure 6-32 Install the