Table 3-4 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
3 - 30
The Expansion cable connects the Controlling Chassis and its
PZ-BS10 interface to the second, third, and fourth PZ-BS11
interface.
Use only the CAT 5 cables provided by NEC to make the
connections between the Controlling and Expansion Chassis.
The PZ-BS10 provides:
Communication Processor Interface for data handling through

Communication Channel (24 slots maximum)
64 Channels for Telephony Resource (e.g., DTMF Tone

Receiver, Call Progress Tone Detector, MFC Tone Receiver,
Caller ID Receiver, Caller ID Signal Sender)
DSP Resource Management

3.5.2.1 Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 3-4 PZ-BS10/PZ-BS11 Connector Pin-Out

PZ-BS10 – CN2, CN3, CN 4
3.5.2.2 Install the PZ-BS10 Expansion Base Blade in the
CHS2U B-US Controlling Chassis
1. Ensure the chassis is powered down.
RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Installing the SV8100 Chassis
UNIVERGE SV8100
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)