Figure 9-60 Separate Tilt Leg From Leg Support; Installing The Psa-L Adapter - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
9 - 82
12.5.1

Installing the PSA-L Adapter

Before installing or removing the PSA-L
adapter, remove the line cord, LAN cable, and
then AC adapter from the outlet.
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline
terminal.
 Only one PSA-L UNIT can be attached to the DTL/ITL multiline
terminal.
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
Tilt Leg
4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and
pull the legs toward you, lifting to remove (refer to
Remove Legs From Multiline Terminal on page
Support).

Figure 9-60 Separate Tilt Leg from Leg Support

Installing SV8100 Optional Equipment
UNIVERGE SV8100
Figure 9-60
Stoppers
Figure 9-61
9-83).