Table 4-1 Extension Blade Installation Order Example; Order Of Installing Extension Blades - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
4 - 6
2.2.2

Order of Installing Extension Blades

The order in which the station blades (CD-8DLCA with PZ-8DLCB,
CD-16DLCA, CD-4LCA, and CD-8LCA with PZ-8LCE) are physically
inserted determines the numbering plan.
To avoid unexpected extension/trunk numbering if
the VoIP or Voice Mail daughter board registers
with the system first, install these boards after the
other extension and trunk blades are installed.
For example, when a digital station blade (CD-16DLCA) is in Slot 1
(ext. 101~116) and three additional digital station blades are installed
in the following order, the numbering plan below in
Extension Blade Installation Order Example

Table 4-1 Extension Blade Installation Order Example

Order of
Installation
1
2
3
4
After the initial powering up of the system, subsequent powering up
or reset does not change the slot identification. Program 90-05 must
be performed to change the slot identification.
Adding any daughter board to increase the available ports or go to a
higher capacity blade (e.g., CD-16DLCA) may require that the slot be
deleted in programming and the blade reinstalled. In the following
example, to add a daughter board to slot 2, the blade must be
removed, deleted in Program 90-05-01, then reinstalled with the
daughter board attached, otherwise the additional ports are not
recognized. This however, uses new ports for the combined blade –
the initial ports (ports 17~24 using the example below) are not used.
Blade Slot
Blade
Number
1 CD-16DLCA
2 CD-16DLCA
4 CD-8DLCA
PZ-8LCE
3 CD-8DLCA
Installing the SV8100 Blades
UNIVERGE SV8100
Table 4-1
applies.
Extension
Numbers
101~116
117~132
133~148
149~156