External Page Relays - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

The PGD(2)-U10 ADP provides amplifiers for each

page output port (for a maximum of +8 dBM, 600

ohms at 1KHz). No additional page amplification is

provided by the PGD(2)-U10 ADP but, if required,

an external page amplifier can be used for additional

amplification.

The page output of the CD-CP00-US does not

provide amplification (for a maximum output of -3

dBm, 600 ohms at 1KHz). If the paging volume is not

satisfactory using the CN8 or CN9 connector on the

CD-CP00-US, the PGD(2)-U10 ADP should be used

External Page Relays

Two external dry contact relays are available when a PGD(2)-U10 ADP is

installed which can be used to activate ancillary devices (i.e. door unlock

devices). The CD-CP00-US also provides one page relay. When the relay on

the PGD(2)-U10 ADP is used, there is no need to assign the relay to the Door

Box – connect the relay as detailed in the steps below for the Door Box used.

The relays on the PGD(2)-U10 ADPs are numbered 5~8. Each Door Box/

external page circuit provides a dry relay contact.

If Relays 5 and 6 of a PGD(2)-U10 are set as General

Purpose Relays, they cannot be used for Door Box/Page

Program 10-21-05 sets the relay switch on the

If General Purpose Relay is set to 1 (Relay 1), the page

relay cannot function on the CD-CP00-US. General

Purpose Relays override Paging Relays and the Paging

Relay is associated with Relay 1 on CN10.

The service codes indicated are the default codes. Refer to Program

11-12-20 and 11-12-50 to redefine these codes as needed.