Figure 10-24 Raising The Height On The Dth/Dtr Multiline Terminal; Figure 10-25 Lowering The Base Plate On The Multiline Terminal - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
S 9 A
ECTION DJUSTING THE
The base plate on the multiline terminal is hinged to allow the height of the terminal to
be raised or lowered.
1.
2.
3.
System Hardware Manual
H
EIGHT ON A
Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to
the DTH/DTR Multiline

Figure 10-24 Raising the Height on the DTH/DTR Multiline Terminal

After the height is adjusted, pull the line cord though the groove in the bottom of
the multiline terminal and adjust it.
Push on the adjustment tabs on the side of the stand and push down to lower
the base plate. Refer to
Terminal.

Figure 10-25 Lowering the Base Plate on the Multiline Terminal

M T
ULTILINE ERMINAL
Figure 10-24 Raising the Height on
Terminal.
Figure 10-25 Lowering the Base Plate on the Multiline
Issue 2.0
10 - 19