Table 4-4 Default Port Settings; Port Defaults - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
To program using a multiline terminal, enter programming
mode:
1. Go to any working display telephone.
2. Do not lift the handset.

In a newly installed system, use extension (port 1).
3. Press Speaker.
4.
#  # 
5. Dial the system password + Transfer.
2.6.3.2

Port Defaults

With the default settings, the ports are assigned as follows:
Station Ports:
Virtual
Station Ports:
Trunk Ports:
In the initial configuration:
 All Programmable Function keys are line keys (e.g., key
1 is line 1).
 All trunks are loop start DTMF.
2.6.3.3 Setting Up Extension Circuit Types
Run Program 10-03 to set up extension circuit types as
required. The system automatically detects and assigns
most circuit types when the device is connected.
1. Dial 10-03-01.
2. Press TRANSFER to Select the slot, port or channel
(with ESIU Blades) to be programmed.
3. Set the terminal type or option as needed.

If the system has DSS Consoles, Program 30-02 must be
used to define DSS extension assignments.
.
Password

Table 4-4 Default Port Settings

Port 1~99 : 101~199
Port 100~199 : 3101~3200
Port 200~512 : 3201~3513
Port 1~99 : 201~299
Port 100~199 : 3601~3700
Port 200~256 : 3701~3757
1~200
Issue 2.0
4 - 11