Install Grounding On 9.5" Gateway Or Base Chassis; Install Ac Power Cord 9.5" Gateway Or Base Chassis; Install Additional Blades 9.5" Gateway Or Base Chassis; Apply Power To The 9.5" Gateway Or Base Chassis - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual

Figure 3-26 9.5" Chassis (Rear View)

3.4.1

Install Grounding on 9.5" Gateway or Base Chassis

1. Ensure the 9.5" chassis (CHS2U GW-US or CHS2U B-US) is
powered off and the AC power cord is unplugged.
2. Ground the chassis by connecting a 14 AWG wire from the FG
lug on the back side of the chassis to an electrical service
ground (such as a cold water pipe). Refer to
Chassis (Rear
3.4.2

Install AC Power Cord 9.5" Gateway or Base Chassis

Locate the supplied AC power cord and attach to the AC Inlet located
on the back of the chassis [refer to
View)].
3.4.3

Install Additional Blades 9.5" Gateway or Base Chassis

Refer to Chapter
4-4.
3.4.4

Apply Power to the 9.5" Gateway or Base Chassis

Refer to Chapter
4-9.
View).
Figure 3-26 9.5" Chassis (Rear
4, 2.1 Installation and Safety Precautions on page
4, 2.6 Powering Up the SV8100 System on page
Issue 2.0
Figure 3-26 9.5"
3 - 23