Figure 6-32 Install The Wall Mount Adapter; Mount The Base Unit On A Standard Wall Plate - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
5.4
System Hardware Manual
5. Make sure that the charge LED illuminates.

If the LED does not illuminate, check to see that the AC adapter is plugged in and
the handset makes good contact with the base charging contacts. Refer to
6-31 Connect the Base Unit on page
6. After you install the battery pack in the handset, charge it for at least
15~20 hours before plugging it into the phone line.
7. After the handset battery pack is fully charged, connect the telephone
line cord to the TEL LINE jack and to a telephone outlet. Refer to
6-31 Connect the Base Unit on page

If your telephone outlet is not modular, contact your NEC Representative for
assistance.

Mount the Base Unit on a Standard Wall Plate

This telephone can be installed on any standard wall plate.
1. Make the AC adapter and the telephone line cord through the hole on
the wall mount adapter.
2. Plug the AC adapter in the DC IN 9V jack. Refer to
the Wall Mount Adapter.
3. Plug the telephone line cord in the TEL LINE jack. Refer to
Install the Wall Mount
6-26.
6-26.

Figure 6-32 Install the Wall Mount Adapter

Adapter.
Issue 2.0
Figure
Figure
Figure 6-32 Install
Figure 6-32
6 - 27