Figure 5-64 Ribbon Cable Connector - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
3. Remove the screw (refer to
Side Panel from Multiline Terminal on page
4. Carefully, return the multiline terminal to the buttons
side up.
5. Remove the Softkeys and Line Key kit from the
telephone.
6. Gently lift the small black bar on the ribbon cable
connector (refer to
Connector).

Figure 5-64 Ribbon Cable Connector

7. Plug ribbon cable on back of 8LKD (LD)-L UNIT into
connector until pressure is felt.
8. Press down on the black bar to lock the cable into
place (refer to
on page 5-62).
Figure 5-63 Remove
Figure 5-64 Ribbon Cable
Lift
Here
Figure 5-65 Ribbon Cable Installed
Issue 2.0
5-60).
5 - 61