Figure 3-140 9.5" Battery Terminal Cover; Chs2U Gw-Us) Or Base (Chs2U B-Us Chassis Connection - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
3 - 110
8.4.2 CHS LARGE BATT BOX to 9.5" Gateway (CHS2U GW-US) or Base
(CHS2U B-US) Chassis Connection
1. Power down the CHS2U GW-US or CHS2U B-US chassis.
2. Disconnect AC power cable from rear of chassis.
3. From the back of the 9.5" chassis, remove the black plastic
square covering the two-prong battery terminal leads (refer to
Figure 3-140 9.5" Battery Terminal
4. Connect one end of Battery Connection Cable to Battery
Connector on rear of 9.5" chassis.
5. Connect other end of cable to Battery Connector on rear of
CHS LARGE BATT BOX chassis (refer to
LARGE BATT BOX to CHS2U GW-US or CHS2U B-US
Connection on page
Ensure the CHS2U GW-US or CHS2U B-US
chassis is powered OFF.

Figure 3-140 9.5" Battery Terminal Cover

3-111).
UNIVERGE SV8100
Cover).
Figure 3-141 CHS
Installing the SV8100 Chassis