Figure 9-45 In-Line Power Adapter; Conditions - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

NEC power supply PoE-managed switch (BlueFire 200/24) (in-line and

spare pair detection)

Router Blade (spare pair detection)

Cisco Data Switch – CDP supported (in-line and spare pair detection)

In-Line Power Adapter

Only IP telephones supported by center feed can be used.

This adapter cannot be used with the H.323 telephones.

When center feed is used, unplug the adapter from the

ethernet switch before changing the SW1 setting on the back of

the adapter.

The ILPA-R adapter is intended for use with IP phones and IP

Adapters. Installing any other device into the telephone port of

the ILPA-R may result in damage to the device.

When powering an IP phone using an ILPA-R adapter, the

phone should not be connected to a port on the Router Blade.

Figure 9-45 In-Line Power Adapter

Installing SV8100 Optional Equipment

UNIVERGE SV8100