Figure 5-29 Installing The Line Key Panel; Configuring The Digital Telephone For The Correct Number Of Line Keys - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
9. Install the supplied Line Key Panel (refer to
Installing the Line Key
available for the 12 and 24 button LK Panels (refer to
1, Table 1-8 DT300/DT700 Series Optional Equipment List on
page 1-10).
10. Install the side panel.
11. Connect the line cord/LAN cable and the AC/DC adapter to the
DTL/ITL multiline terminal.
4.5.2 Configuring the Digital Telephone for the Correct Number of Line
Keys
1. With the telephone not plugged in and the handset on-hook,
press the 4 and 6 buttons on the numbered keypad and
connect the telephone cable.
 This places the telephone into Service Class Read/Write (R/W) mode.
The Message Waiting (MW) LED should be On.
2. Press 1 to enter the Line Key Type mode.
 The Message Waiting LED should flash.
Panel). A variety of colors is now

Figure 5-29 Installing the Line Key Panel

Issue 2.0
Figure 5-29
Chapter
Line Key
Panel
5 - 33