Installing The Repeater - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
7.2
6 - 48
7.1.4 Registration for a Daisy-Chain Layout
Registering the repeaters to operate in a daisy-chain or sequential
layout requires network administrator access and configuration
software. Contact your installer or refer to the DTL-RPT-1
Administrator's Guide (provided with the configuration software) for
more information.
7.1.5 Registering to a Different Base
After the repeater is registered, you must reset it before you can
change the registration to a different base. If you want to reset the
repeater and clear its registration, follow the steps below:
1. Disconnect the power.
2. Connect the power for one to five seconds, and disconnect it
again.
3. Connect the power for 25~35 seconds.
4. Disconnect the power, and perform the registration procedure
with the new base.

Installing the Repeater

7.2.1 Finding the Right Location
To get the best operating conditions for the repeater, it is important to
place it correctly. Here are a few tips for placing repeaters:
Place the repeater as high as possible, but at least six feet above

the floor.
Make sure you have good reception from the base.

Make sure the location is close to a standard 120 V AC power outlet.

Never install electrical cords across a traffic area: they can create a
trip hazard or become damaged and create a fire or electrical hazard.
Allow at least 30 feet between repeaters (if you are installing

repeaters across multiple floors, remember to allow 30 feet
vertically, also).
Avoid sources of electrical interference, such as hi-fi systems, office

equipment or microwave ovens.
Avoid heat sources and direct sunlight.

Avoid things that can interfere with radio signals, such as metal

doors, thick walls, niches and cupboards.
UNIVERGE SV8100
Installing SV8100 Cordless Telephones