Installation; Connecting The Telephone Network; Wall Mounting - NEC AT-50 User Manual

Caller id business telephone
Hide thumbs Also See for AT-50:
Table of Contents

Advertisement

INSTALLATION

Connecting the Telephone Network

Connect the telephone to the telephone network with following steps.
1.
Connect the one end of the line cord to the LINE socket on the rear of telephone and the
other end to your telephone network outlet.
2.
Lay the handset cord in the groove on the bottom of the telephone.
IMPORTANT
Do not connect with the public telephone network directly. This telephone is manufactured for
connection to the line provided by the KTS/PBX systems.
Do not connect other analog devices such as FAX/telephone on the same line. Since this telephone is a
Caller ID terminal, parallel connection on the same line is not guaranteed.
If the other analog terminal is connected to the same line with this telephone, this telephone does not
operate properly.
The Caller ID receiver of KTS/PBX systems shall be set to FSK mode. This telephone is not supported
Caller ID with DTMF signaling.

Wall Mounting

This telephone can be mounted on a wall with two screws. The screws shall be supplied by
customer.
1.
Mark off the correct positions for the screws, 83.5mm apart vertically before drilling the
wall.
2.
Install the screws into the wall.
3.
Mount the telephone on the wall so that the screw heads insert into the slots on the
underside of the telephone.
3
INSTALLATION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents