Figure 4-32 Pri Layout For Nt-1 Network; Installation - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
5.6.2

Installation

To install the CD-PRTA:
1. Plug the CD-PRTA into any universal slot in the chassis.
2. Use Program 10-51-01 (PRI/T-1) to set the CD-PRTA blade to
either PRI or T-1.
3. Connect the cable from the NT1 Network Termination cable to
the CN2 connector on the CD-PRTA.
for NT-1 Network on page 4-85

Figure 4-32 PRI Layout for NT-1 Network

With normal operation, LED 1 flashes green.
is a cabling diagram.)
The CSU connects to the network through

an 8-pin RJ-45/RJ48C connector. Use
either the RJ48C plug-to-RJ48C plug,
which ships with the CSU or an RJ-45/
48C plug-to RJ-45/48C plug straight
through or CAT5 cable to connect the T1
to the CSU. (Refer to
CD-PRTA RJ48C Connector Pin-outs on
page 4-88.)
With PRI Networking, a crossover cable

must be used on the master system T1/PRI
blade or CSU to the telco demarcation. If
the systems are networked side by side and
not through telco, a straight-through
cable is used.
Issue 2.0
Figure 4-32 PRI Layout
Table 4-44
4 - 85