Figure 6-62 Incorrect Installation; Installing The Repeater - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

Be sure the wall material can hold the weight of

the repeater. Never install a repeater in damaged

or decaying wall material.

Hold the repeater in its final location, and mark the center of the

From the edge mark, measure down approximately 1-1/2

inches, and mark the screw location.

At the screw location, use a 3/16ths drill bit to make a pilot hole

approximately one inch deep.

Place the wall anchor into the pilot hole and tap it gently with a

hammer until the anchor is flush with the wall.

Insert the mounting screw into the anchor, leaving

approximately 1/4 inch space between the screw head and the

Put the repeater over the screw head and slide it down into

Connect the repeater to the 120V AC power outlet.

Multiple Repeater Systems

You can register up to six repeaters to one base as long as the

repeaters are a minimum of 30 feet apart. Remember that the signal

can cross through walls and floors.

Incorrect Installation

Figure 6-62 Incorrect Installation on page 6-51

repeaters that are incorrectly installed.

UNIVERGE SV8100

Installing SV8100 Cordless Telephones