Issue 2.0
9 - 74
Tilt Leg
Figure 9-49 Separate Tilt Leg from Leg Support
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6.
Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout).
Knockout
Figure 9-50 Bottom Option Interface Knockout
7.
Using the exposed Bottom Option Interface as a guide, install
the ADA-L UNIT in the bottom of the DTL/ITL multiline terminal.
Push down until left and right tabs are seated (Refer to
9-51 Install ADA-L UNIT on page
Figure 9-50 Bottom Option Interface
9-75).
Installing SV8100 Optional Equipment
UNIVERGE SV8100
Stoppers
Bottom Option
Interface
Figure