Section 8 Music Sources - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
M
S 8
USIC
ECTION
8.1
8.2
System Hardware Manual
15-12-02 : Conversation Recording Destination for Extensions –

ACI Automatic Recording for Incoming Call
Determine whether an extension should be automatically recorded when an
incoming call is received (0=Off, 1=On).
External Ringer
31-05-01 : Universal Night Answer/Ring Over Paging

For each trunk port which should ring the external ringer, enter 1.
S
OURCES
Music on Hold
The system can provide Music on Hold from either an internally synthesized
source on the CD-CP00-US or from an external source. The external MOH
can be a tuner, tape deck, CD player, etc. The settings in Program 10-04-01
and 14-08-01 determine whether the source for MOH is internal or external.
In addition to a connector on the CD-CP00-US, the PGD(2)-U10 ADPs also
provide connections for external MOH sources. When using external music
sources for external MOH, programming determines the MOH source for each
trunk.
The CD-CP00-US provides a dry relay that activates when a call is placed on
Hold. When an external MOH source is connected to the MOH relay and a call
is placed on Hold, the MOH relay is activated. This allows an external relay
sensor/power supply to turn on the MOH source.
This arrangement allows the MOH source (e.g., a tape deck) to run only when
a call is placed on Hold. The maximum applied voltage for the relay is 24vDC
at .5A (the relays are normally open and close when a call is put on hold).
Installing External Music on Hold
To connect to the CD-CP00-US
1. Connect an RCA line from the CN8 or CN9 connector on the
CD-CP00-US to the appropriate location on the extension cross-connect
block.
2. Connect the two-conductor station cable from the cross-connect block to
the external music source.
3. Install bridging clips as required.
OR
Issue 2.0
9 - 23