Figure 3-139 Replacing The Chsgw Small Batt Box Fuse; Box) To The 9.5" Gateway (Chs2U Gw-Us) Or Base Chs2U B-Us) Chassis - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

Replace the battery connection cables to the battery box.

Figure 3-139 Replacing the CHSGW SMALL BATT BOX Fuse

Installing the External Batteries (CHS LARGE BATT BOX) to the

9.5" Gateway (CHS2U GW-US) or Base (CHS2U B-US) Chassis

An optional, CHS LARGE BATT BOX can be installed to provide external

battery power to the CHS2U GW-US chassis during a power failure. The

long-term battery box powers the system for approximately three hours.

Because of injury from falling equipment, wall mounting

the CHS LARGE BATT BOX is not recommended.

Mounting the CHS LARGE BATT BOX directly on the

floor is not recommended.

Due to possible water damage, floor mounting the 9.5"

chassis is not recommended by NEC.

The CHS BASE UNIT raises the height of the CHS

LARGE BATT BOX 120mm (4.72").

CHS LARGE BATT BOX Installation

To install the batteries in the CHS LARGE BATT BOX, refer to

8.2.2 Battery Installation on page