Figure 9-7 Pgd(2)-U10 Adp Connections - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
9 - 8

Figure 9-7 PGD(2)-U10 ADP Connections

9. Install a modular jack for each PGD(2)-U10 ADP. For each module, run
one-pair 24 AWG station cable from the cross-connect block to a
modular jack. Ground the unused pair.
10. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
11. Install bridging clips as required.

For the module to ID correctly, set the circuit type to 0 for the port in Program
10-03-01 prior to connecting the line cord.
12. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP.
UNIVERGE SV8100
Installing SV8100 Optional Equipment