Install The 4- Or 16-Port Digital Call Logging Unit - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
2. After USB cards are installed, go to
www.windowsupdate.com. Download and install
any updated device driver that may be available for
WIN2000 or XP and your USB Controller Cards.
This is very important, as WIN2000 does not always
have the required device drivers loaded in default
for USB 2.0 devices. If your card came with a driver
CD this step may have been taken care of during
installation of the card.
3. Update Windows 2000 to Service Pack 4; this is
available as a free upgrade from the Windows
update web site.
4. When all USB Controller Cards are installed and the
PC updated, restart the PC.
5. Connect any USB hubs if applicable.

6. After USB hubs are installed, restart the PC again.
11.5.6.3

Install the 4- or 16-Port Digital Call Logging Unit

1. Connect the 4- or 16- Port Digital Call Logging Unit
device to the USB cable and plug the USB cable in
the PC. Windows responds with the Found New
Hardware wizard.
2. Insert the provided NEC BackOffice CD in the CD
drive of the PC.
Direct the installation of the driver to Specific
Location and specify the Driver folder on the CD.
Windows should find and load the device driver.
3. Before inserting the next USB cable, restart the
PC. If Windows responds with Found New
Hardware again, direct to the CD a second time and
restart the PC. After you get a clean restart and
Windows recognizes the device on restart, install
the next device.
The brand or type of USB hub must match that of the
USB Controller Card.
Issue 2.0
9 - 49