Chs2U-Us Chassis - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
R
S 10
EMOVE AND
ECTION
If required, the cooling fan installed in the CHS2U-US chassis can be removed and
replaced. Follow the procedure below for the CHS2U-US chassis.
10.1
3 - 112
I
NSTALL

CHS2U-US Chassis

10.1.1 Remove Cooling Fan
To reduce the possibility of electrical shock or
damage to equipment, NEC recommends
powering off the chassis and disconnecting the
AC cable from the power source before
removing the chassis cover.
1. Ensure the chassis is powered down.
2. Loosen retaining screw from chassis access panel.
C F
OOLING AN
To reduce the possibility of damage to
equipment, the installer must wear a
grounded wrist strap to protect the
equipment from static electricity.
Figure 3-142 19" Chassis Access Panel
UNIVERGE SV8100
Retaining Screw
Installing the SV8100 Chassis