Figure 3-68 Wall Mount Positioning For 9.5" Base/Expansion Chassis - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
4.3
System Hardware Manual
11. Using the key-holes as a guide, slide the assembled unit over
the screws previously installed in the wall (refer to
Install Screws (Option 2) on page
12. Connect grounding wire to chassis. Refer to Chapter 4
paragraph
and Base (CHS2U B-US) Chassis on page 3-22
details on grounding the system.
13. Refer to
Chassis on page 3-23
Chapter 6 paragraph
page 4-4
Wall Mounting the 9.5" Base (CHS2U B-US) and Expansion
(CHS2U E) Chassis
When wall mounting the 9.5" Base and Expansion chassis, ensure the wall
can support the weight of the chassis (9.48 lbs per each 3-slot chassis –
including blades, cords, power supply, etc.). For proper air circulation, the
chassis must be secured to the wall sideways (refer to
Positioning for 9.5" Base/Expansion
Ensure enough space is available above and below to allow installation of
additional expansion chassis.

Figure 3-68 Wall Mount Positioning for 9.5" Base/Expansion Chassis

3.4 Installing the 9.5" Gateway (CHS2U GW-US)
3.4.2 Install AC Power Cord 9.5" Gateway or Base
for installation of the power cord or,
2.1 Installation and Safety Precautions on
for installation of blades.
Chassis) with a wall mount bracket.
Issue 2.0
Figure 3-62
3-54).
for complete
Figure 3-68 Wall Mount
3 - 59