Setting Up Your Repeater - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
7.1
6 - 46

Setting Up Your Repeater

Before installing the repeater, you must activate the repeater mode on your
base and then register the repeater to the base and any handsets. Before you
start the registration process, be sure you have:
 A working base
 A working handset registered to that base
Any repeaters you want to register to this base (you must complete the

registration process separately for each repeater)
At least one of the AC adapters supplied with the repeaters


Use ONLY the power adapter that came with your repeater. A different power
adapter may cause an electrical hazard or damage the repeater.
7.1.1 Changing the Telephone System PIN
Before you start the registration process, you must reset the system
PIN of your telephone to
your base for more information). After you reset the PIN, make sure
to register the handset you used back to the base station.
7.1.2 Automatic Registration
The repeater seeks out the base with strongest DECT/GAP signal
and automatically registers to that base.
1. Make sure the repeater is powered off (i.e., the AC power
adapter is not connected).
2. Set the base in registration mode. (Consult the owner's manual
that came with your base station for more information.
3. Use the AC adapter to connect the repeater to a standard 120
V AC outlet. (Do not use a power outlet controlled by a wall
switch.) The LED on the repeater flashes briefly, then remains
on and steady.
 If the LED continues to flash, register the repeater again.
The repeater is now registered to this base and is ready to use.
You can safely disconnect the power and move the repeater to the
selected location; the repeater stays registered to the base.
(consult the manual that came with
0000
Installing SV8100 Cordless Telephones
UNIVERGE SV8100