Figure 4-38 Install The Cr-2032 Battery; Installation - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
4 - 96
One 15-pin VGA connector for VHA monitor support

6.1.2

Installation

Only one CD-VM00 can be installed per system.


1. Wear a grounding strap while handling the CD-VM00 and lay it
on a flat workspace.
2. Mount the CR-2032 battery with the + side up in the BATT slot
on the CD-VM00 (refer to
Battery).
3. To Install the SO-DIMM memory on the CD-VM00 blade, insert
the end with the brass connectors into the CN14 1 slot first.
4. Push the other end down until the lock on both sides locks into
place (refer to
page 4-97).
Handle the CF drive carefully. To prevent
damage, do not drop the drive or apply pressure
to it.
This unit makes extensive use of CMOS
technology and is very susceptible to static;
extreme care must be taken to avoid static
discharge when handling.
Figure 4-38 Install the CR-2032

Figure 4-38 Install the CR-2032 Battery

Figure 4-39 Install the SO-DIMM Memory on
UNIVERGE SV8100
Installing the SV8100 Blades