NEC Univerge SV8100 System Hardware Manual page 269

UNIVERGE SV8100
System Hardware Manual
MFC Tone Sender

MF Signal Sender (Sends caller information to CO for E911)

Call Progress Tone Detection

C-Channel Control

Conference: 64 Channels

Caller ID Receiver; 32 Channels

A load switch which is used for initial system startup, resetting the

system, or when upgrading system software
One Serial Port (null modem/cross-over cable required)

One USB Port – USB 1.1 (requires USB driver – download from NEC

web site)
 Memory size – minimum of 32MB (normally 512MB or 1GB) should be
used.
 USB device power consumption is less than 200mA (1W).
One Gbit Ethernet Port for VoIP function

One CompactFlash Card Slot

Background Music/EXSP Control Port

Status LED

Two Audio Input/Output Terminals

One Music On Hold External Source

High-Level Data Link Control (HDLC) Packet Processing

Real Time Clock (tolerance 30 seconds/month)

Call Control Server (ex: Conference Bridge Server, Voice Mail Server,

SIP Server, RTP Forwarding, VoCoder Conversion)
One lithium battery (Sony CR2032 or equivalent) which provides

battery back-up of system data and RAM memory for approximately 30
months.
The CD-CP00-US functions provided are:
Call Control Server

Conference Bridge Server

Voice Mail Server (voice mail requires a compact flash card)

SIP Server

RTP Forwarding

VoCoder Conversion

Issue 2.0
4 - 19