Manual Registration - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
7.1.3

Manual Registration

If you are registering more than one repeater to the same base, you
must use the manual registration procedure.
1. Connect the repeater to power for 1~5 seconds and then
disconnect it.
2. Reconnect the power to the repeater. The LED on the repeater
flashes slowly, indicating the repeater is in registration mode.
 The repeater stays in registration mode for five minutes. If you cannot
complete the registration in five minutes, repeat the procedure
starting with step 1.
3. Set the base in registration mode. (Consult the owner's manual
that came with your base station for more information.)
4. The LED on the front of the repeater flashes quickly, with no
interruptions.
 If the LED has brief interruptions in the flash, you need to reset your
telephone system PIN to 0000. (Refer to
Telephone System PIN on page
5. Press the handset TALK? key to go off-hook. The LED stops
flashing.
6. Use the number pad on the handset to assign a repeater
number. Press a number between 2 and 7. Each repeater
number can be used only once per base. (These numbers are
independent of any handset extension number.)
7. When the repeater accepts the assignment, the LED flashes a
corresponding number of times.
8. Press the STAR? key to confirm the registration, and then the
END? key. The LED goes off for two seconds, flashes for a
brief moment, and then remains on steady.
The repeater is now registered to this base station. You can repeat
the procedure with each repeater that you want to register to this
base, or you can disconnect the power and move the repeater to the
selected location.

The repeater remains registered even if you disconnect the AC adapter or there is a
power failure. If you want to clear the registration (for example, so you can register
to a different base), you must reset the repeater.
7.1.1 Changing the
6-46.)
Issue 2.0
6 - 47