NEC Univerge SV8100 System Hardware Manual page 310

Hide thumbs Also See for Univerge SV8100:

Table of Contents

The PZ-4LCA and PZ-8LCE daughter boards are mounted on the

CD-4LCA/CD-8LCA. These boards provide:

4-Port Single Line and 8-Port Single Line analog extension ports (used

for on-premise analog telephones, fax machines, and analog modems).

The CD-4LCA/CD-8LCA is not rated for OPX use. A CD-4DIOPA blade

should be used instead (it supports the analog DID and single line

telephone interface functions, such as Off-Premise Extensions).

Connector for CD-4LCA and CD-8LCA Blades

Ring Generator

Caller ID Sending Ability

Message Wait Lamp Ability

Constant current type battery feeding (25mA / -28Vdc)

Feeding Polarity Reverse Ability

Each CN2 (PZ-4LCA

provides connection to four analog station ports and is not polarity

sensitive. The PZ-8LCE consumes eight ports ranging between ports

001~256 (remember that the CD-8LCA consumes eight ports).

Refer to the following tables for maximum upgrade capacity of the

PZ-8LCE SLI daughter board:

Table 2-6 SV8100 Maximum 9.5" Gateway and 19" System Capacities

– Blades on page 2-13

Table 2-7 SV8100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-15

Installation

PZ-8LCE) or CN3 (PZ-8LCE only) connector

When connecting a fax machine or analog

modem, make sure to set Program 15-03-03 to

1 (special terminal) to avoid communication

The CD-4LCA/CD-8LCA blade and the

PZ-4LCA/PZ-8LCE daughter board are

categorized as TNV2. With this designation,

off-premise wiring is not acceptable. Any

cabling to these blades or daughter boards

must be in the building – no outside cabling is

Branch connection is not acceptable.

UNIVERGE SV8100

Installing the SV8100 Blades