Figure 6-46 Inserting Screws Into The Wall For Wall Mounting The Telephone; Mounting The Base Directly To The Wall - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

If a standard wall plate is not available, mount the telephone directly on the

wall. Before mounting the telephone, consider the following:

Select a location away from electrical cables, pipes, or other items behind

the mounting location that could cause a hazard when inserting screws into

Make sure the wall material can support the weight of the base unit.

Use #10 screws with anchoring devices suitable for the wall material where

the base unit will be placed.

To mount the telephone:

Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an

inch between the wall and screw heads for mounting the telephone.

Figure 6-46 Inserting Screws into the Wall for Wall Mounting the Telephone

Plug in and secure the AC adapter.

Plug the AC adapter into the base unit.

Plug one end of the short telephone cord into the LINE jack on the base

unit. Then plug one end of an NEC multiline terminal into the PHONE

jack. Place the telephone cords inside the molded channels on the

bottom of the wall mount stand.