Direct Wall Mounting; Figure 8-15 Inserting Screws Into The Wall For Wall Mounting The Telephone - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
4.7
System Hardware Manual

Direct Wall Mounting

When a standard wall plate is not available, mount the telephone directly on
the wall. Before mounting the telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind
the mounting location that could cause a hazard when inserting screws into
the wall.
Make sure the wall material can support the weight of the base unit.
Use #10 screws with anchoring devices suitable for the wall material.
To mount the telephone:
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an
inch between the wall and screw heads for mounting the telephone.

Figure 8-15 Inserting Screws into the Wall for Wall Mounting the Telephone

2. Plug in and secure the AC adapter.
3. Plug the AC adapter into the base unit.
4. Plug one end of the short telephone cord in the LINE In JACK on the
base unit. Then plug a multiline terminal line in the LINE OUT jack.
Place the telephone cords inside the molded channels on the bottom of
the wall mount stand.
Issue 1.0
8 - 15