Wall Mounting - NEC UNIVERGE DT920 Series User Manual

WALL MOUNTING

A wall mount unit (WM-L UNIT) is used to mount all telephones
to the wall. This unit connects to the back side of the telephone.
Be careful not to drop the telephone set while mounting
it on the wall. It can cause injury. Make sure the
telephone set is firmly mounted on the wall to prevent the
telephone set from falling out. It can cause injury.
To mount the telephone set on the wall, the following space is
required.
To mount the telephone set on the wall, use the following
procedure.
1.
Mount the hanger of the handset upside down.
Remove the hanger from the handset once.
Turn it upside down and then insert the hanger
until you hear it clicks.
2.
Turn the telephone set upside down and widen
the tilt leg.
3.
Attach WM-L UNIT to the wall directly or the wall
plate.
- When attaching WM-L UNIT to the wall directly:
Secure WM-L UNIT with the six screws (included
with the telephone set) or hang WM-L UNIT on
the wall with the two screws (purchased
separately) inserted into the wall.
INSTALLATION PROCEDURE
- When attaching WM-L UNIT to the wall plate:
Attach WM-L UNIT to the posts on the wall plate
as shown in the figure below.
For the DT920 series the installation of wall mount unit is
completed with this step, and connect LAN cable to the terminal.
For the DT530 series, continue to the following steps.
4.
Attach the modular terminal to the wall as shown
in the following figure. If the modular connector
is attached directly on the wall or the wall plate is
used instead of modular terminal, skip this step.
23