Blade Startup; Initial Extension Blade Installation - NEC UX5000 Hardware Manual

S 2-9
ECTION

BLADE STARTUP

2.9.1

Initial Extension Blade Installation

1. Plug the blades into each chassis slot in numerical order. The order in which the station blades (SLIU,
ESIU, 082U) are physically inserted determines the numbering plan. The installer must install
extension blades in order (i.e.; slot 2 first, slot 3 next, slot 4 next, etc.) for a sequential numbering plan.
For example, with a 16ESIU in slot #2 (ext. 301-316), when 3 more 16ESIU blades are installed in the
following order, the numbering plan below would apply:
Adding a daughter board to increase the available ports or going to a higher capacity blade (ex: 8ESIU to
a 16ESIU) may require that you delete the slot and reinstall the blade. In the following example, to add a
daughter board to slot 3, the blade must be removed, deleted in Program 90-05-01, then reinstalled with
the daughter board attached otherwise the additional ports would not be recognized. This however, will
use new ports for the combined blade - the initial ports (ports 17-24 using the example below) are not
used.
Initial Setup
Blade Slot
#
2
3
(no daughter
4
2. The system will automatically recognize each blade as it is installed in the system. If a blade has
previously been installed in a slot and another type of blade is to be installed in that same slot, the blade
must be first be removed from the chassis and then the slot definition removed using Program 90-05
prior to installing the new blade.
This same condition applies to extensions and other devices connected to the system. For example, if a
port was previously used for a keyset and a DSS Console is to be installed in that same port, it must first
be undefined in Program 10-03 before the console is connected.
Chapter 2
Order of
Install
1
2
3
4
Extension
Blade
Numbers
16ESIU 301-316
8SLIU 317-324
board)
16ESIU 325-340
Chapter 2 - Blade Installation and Startup
Blade Slot # Blade
2 16ESIU
3 16ESIU
5 8SLIU
(no daughter
board)
4 8ESIU
Blade Slot
#
2
3
4
5
Extension
Numbers
301-316
317-332
333-340
341-348
Updated Setup
Extension
Blade
Numbers
16ESIU 301-316
---
16ESIU 325-340
8SLIU 341-356
(with daughter
board)
2 - 89