Figure 5-7: Connecting A Multiline Terminal To A Recording Device Using; An Ad(A)-R( ) Unit (Example); Figure 5-8: Ad(A)-R( ) Unit Connection Without Pause Control; Figure 5-9: Ad(A)-R( ) Unit Connection With Pause Control - NEC Xen alpha Installation Manual

Installation Manual, Chapter 5 – Installing Dterm Series i Optional Equipment
November 2003, A6-506000-642-01(8508), Release 6.0
Figure 5-7: Connecting a Multiline Terminal to a Recording Device using an
AD(A)-R( ) Unit (Example) illustrates how a terminal with an AD(A)-R( ) Unit is
connected to the ESI(8)-U( ) ETU and to the recording device.
Dterm Series i Multiline Terminal + AD(A)-R( ) Unit
ESI
ETU
Line Cord
(2-line)
Figure 5-7: Connecting a Multiline Terminal to a Recording Device using an AD(A)-R( )
When installing the AD(A)-R( ) Unit, first connect the cables to the AD(A)-R( )
Unit, second set the dip switches and then install the AD(A)-R( ) Unit on the
Multiline Terminal.
3.2.1 Connecting Cables to the AD(A)-R( ) Unit
The first step in installing the AD(A)-R( ) Unit is to connect the cables
between the recording device and the AD(A)-R( ) Unit.
Cable terminal connectors are located on the side of the AD(A)-R( )
Unit. Cables should be connected on this unit before installing the
unit on the Multiline Terminal.
Cables can be connected to determine whether or not pause control
is provided for the recording.
Recording
Device
Mini-Plug
Earphone
Connection Cord

Figure 5-8: AD(A)-R( ) Unit Connection without Pause Control

Mini-Plug
Remote
Recording
Device
Mini-Plug
Line In

Figure 5-9: AD(A)-R( ) Unit Connection with Pause Control

Unit (Example)
Mini-Plug
CN2
Mini-Plug
Connection Cord
T6 (Shielded Wire)
T7 (Wire)
Mini-Plug
Connection Cord
CN2
Recording
Device
Mini-Plug Mini-Plug
Connection Cord
AD(A)-R( ) Unit
AD(A)-R( ) Unit
113