Create A User Group - Cisco NCS 1002 System Setup And Software Installation Manual

Create User Profiles and Assign Privileges
commit-Saves the configuration changes and remains within the configuration session.
end-Prompts user to take one of these actions:
• Yes-Saves configuration changes and exits the configuration session.
• No-Exits the configuration session without committing the configuration changes.
• Cancel-Remains in the configuration session, without committing the configuration changes.
What to do next
• Create user group that includes the user created in this task. See
• Create command rules that apply to the user group. See
• Create data rules that apply to the user group. See

Create a User Group

Create a new user group to associate command rules and data rules with it. The command rules and data rules
are enforced on all users that are part of the user group.
The NCS 1002 supports a maximum of 32 user groups.
Before you begin
Create a user profile. See
Procedure
Step 1
admin
Example:
RP/0/RP0/CPU0:ios# admin
Enters System Admin EXEC mode.
Step 2
configure
Example:
sysadmin-vm:0_RP0# configure
Enters System Admin Config mode.
Step 3
aaa authentication groups group group_name
Example:
sysadmin-vm:0_RP0#(config)#aaa authentication groups group gr1
Creates a new user group (if it is not already present) and enters the group configuration mode. In this example,
the user group "gr1" is created.
Create a User Profile, on page
System Setup and Software Installation Guide for Cisco NCS 1002
Create a User Group, on page
Create Command Rules, on page
Create Data Rules, on page
37.
Create a User Group
39.
40.
43.
39