Remove The Fan Tray Air Filter From A C8300-2N2S-4T2X|6T; Remove The Fan Tray From A C8300-1N1S-4T2X|6T - Cisco Catalyst 8300 Series Hardware Installation Manual

Install Internal Components and Field Replaceable Units
2
3

Remove the Fan Tray Air Filter from a C8300-2N2S-4T2X|6T

To insert the fan tray, complete the following steps:
Step 1 Loosen the middle captive air filter screws.
Step 2
Pull the old air filter out.
Step 3 Insert the replacement fan tray and tighten the captive screws.
Figure 66: Reinstall the Fan Tray Air Filter (Cisco 8300-2N2S-4T2X|6T)
1
2
3
Note • First inspection of the air filter must be performed six months after the first installation of the air filter.
• Air filters must be inspected every three months after the initial six month inspection and replaced if found
to be dirty.
• Air filters cannot be cleaned and reused. Replace with a new air filter. It is recommended to have spare
air filters in stock.

Remove the Fan Tray from a C8300-1N1S-4T2X|6T

The C8300-1N1S-4T2X|6T supports forward air flow (standard version).
Remove the Fan Tray Air Filter from a C8300-2N2S-4T2X|6T
PSU 1
PSU 0
Air filter cover
Captive screw for air filter
Air filter
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
87