mtu
Use the
command to set the maximum transmission unit (MTU) size, in bytes, for frames
mtu
that ingress or egress the interface. You can use the
support for physical and port-channel (LAG) interfaces. For the standard D-Link Unified
Wired/Wireless Access System implementation, the MTU size is a valid integer between 1522
- 9216 for tagged packets and a valid integer between 1518 - 9216 for untagged packets.
To receive and process packets, the Ethernet MTU must include any extra
NOTE:
bytes that Layer-2 headers might require. To configure the IP MTU size,
which is the maximum size of the IP packet (IP Header + IP payload), see
mtu"
on page 124.
Default
Format
Mode
no mtu
This command sets the default MTU size (in bytes) for the interface.
Format
Mode
shutdown
This command disables a port.
You can use the
NOTE:
interfaces, but not on VLAN routing interfaces.
Default
Format
Mode
no shutdown
This command enables a port.
Format
Mode
shutdown all
This command disables all ports.
You can use the
NOTE:
(LAG) interfaces, but not on VLAN routing interfaces.
Default
1518 (untagged)
mtu <1518-9216>
Interface Config
no mtu
Interface Config
command on physical and port-channel (LAG)
shutdown
enabled
shutdown
Interface Config
no shutdown
Interface Config
command on physical and port-channel
shutdown all
enabled
2 Switching Commands
command to configure jumbo frame
mtu
Port Configuration Commands
"ip
39