Advertisement
T16B_nCCCTLm.
TOUTMD[2:0]
T16B_nCCCTLm
bits
.TOUTMT bit
0
0x4
1
0
0x3
1
0
0x2
1
0
0x1
1
0x0
*
Bit 1
TOUTINV
This bit selects the TOUTnm signal polarity.
1 (R/W): Inverted (active low)
0 (R/W): Normal (active high)
The T16B_nCCCTLm.TOUTINV bit is control bit for comparator mode and is ineffective in
capture mode.
Bit 0
CCMD
This bit selects the operating mode of the comparator/capture circuit m.
1 (R/W): Capture mode (T16B_nCCRm register = capture register)
0 (R/W): Comparator mode (T16B_nCCRm register = compare data register)
17-34
TOUT generation mode and operations
Output
Count mode
signal
Toggle mode
All count modes
TOUTnm
All count modes
TOUTnm
TOUTnm+
1
Set/reset mode
Up count mode
TOUTnm
Up/down count
mode
Down count
TOUTnm
mode
All count modes
TOUTnm
TOUTnm+
1
Toggle/reset mode
Up count mode
TOUTnm
Up/down count
mode
Down count
TOUTnm
mode
All count modes
TOUTnm
TOUTnm+
1
Set mode
All count modes
TOUTnm
All count modes
TOUTnm
TOUTnm+
1
Software control mode
All count modes
TOUTnm
Seiko Epson Corporation
Change in the signal
The signal is inverted by the MATCH signal.
The signal is inverted by the MATCHm or
MATCHm+1 signal.
The signal is inverted by the MATCHm+1 or
MATCHm signal.
The signal becomes active by the MATCH
signal and it becomes inactive by the MAX
signal.
The signal becomes active by the MATCH
signal and it becomes inactive by the ZERO
signal.
The signal becomes active by the MATCHm
signal and it becomes inactive by the
MATCHm+1 signal.
The signal becomes active by the MATCHm+1
signal and it becomes inactive by the MATCHm
signal.
The signal is inverted by the MATCH signal
and it becomes inactive by the MAX signal.
The signal is inverted by the MATCH signal
and it becomes inactive by the ZERO signal.
The signal is inverted by the MATCHm signal
and it becomes inactive by the MATCHm+1
signal.
The signal is inverted by the MATCHm+1 signal
and it becomes inactive by the MATCHm signal.
The signal becomes active by the MATCH signal.
T h e si gn a l be c ome s a c t iv e by t h e
M AT CH m o r MATCHm+1 signal.
The signal becomes active by the MATCH
m +1 o r MATCHm signal.
The signal becomes active by setting the
T16B_nCCCTLm.TOUTO
bit
becomes inactive by setting to 0.
S1C31D50 TECHNICAL MANUAL
to
1
and
it
(Rev. 1.00)
Advertisement
