Macro Command - MA lighting dot2 User Manual

8.37. Macro Command

This page describes the syntax and how to use the marco command.
To go to the macro command, press
Description
With the macro command, you start a macro from the
Syntax
Start a macro.
Macro 1
Example
Let´s assume, you will start macro 1 (e.g. +5 %) to the selected fixtures.
Press Macro 1 Please .
Macro 1 is started.
Related Links
Macro Key
Macro Pool
8.38. MidiNote Command
This page describes the syntax and how to use the
To use the MidiNote command, type
Description
With the MidiNote command, you send MIDI Note messages via the Midi Out port at the back of the console.
If a MIDI channel is entered in the command, the entered MIDI channel will be used.
If no MIDI channel is entered, the MIDI out channel in the
If a velocity is entered in the command, the entered velocity will be used.
If no velocity is entered, velocity 127 (full) will be used.
If the dot2 is in a session, the MIDI Notes messages will be send only on the session master to avoid double traffic.
If the Off command is used, a MidiNote Off is sent.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Macro on the console.
macro pool.
MidiNote
command.
MidiNote Mn
or the short cut
MIDI Show Control window
in the command line.
is used.
424