Go Command - MA lighting dot2 User Manual

8.27. Go Command

This page describes the syntax and how to use the go command.
To go to the go command, press the small
Description
With the go command you can e.g.
go to the next cue of a cue list
start running an executor
Syntax
1. Go to the next cue of a cue list.
Go
2. Start running an executor.
Go Executor 1
Example 1
Let´s assume, the executor 1 is running and you will go forward to the next cue on the cue list stored on executor 1.
There are two ways to do this.
a) Press the small Go + (= Go) and the respective executor button
b) Press the small Go + (= Go) and tap on the respective executor in the
The next cue is running.
Example 2
Let´s assume, the executor 1 is off and you will start it running.
There are two ways to do this.
a) Press the small Go + (= Go) and the respective executor button
b) Press the small Go + (= Go) and tap on the respective executor in the
The executor starts running with the first cue.
Related Links
Small Go + Key
Executor Go Key
8.28. GoBack Command
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Go + on the console.
.
executor bar view.
.
executor bar view.
412