MA lighting dot2 User Manual page 161

E.g. you have a selection of fixtures at a dimmer value of 50% and you want to lower it 20%. Here's what you type
(you have already selected the fixtures):
At - 2 0 Please
That would do the trick.
There's a little extra function to the
could have archived the same by pressing the
Absolute value or relative value
The description above is about setting a relative value. You can also set an absolute negative value on attributes like
pan and tilt.
The difference between a relative or absolute value is a space between the minus sign and the number.
To set a relative value you could write in the command line
absolute value would be written
If you want to use the keys, then you can press
minus while typing the value removes the space between the sign and the value.
Using the calculator (you can get this by a short tap on the encoder for the value you want to set) you can tap the
+/- button to add the sign without a space. For relative values you can use the - button.
Page selection
You can use the - key to change the active page. If you want to go to the previous page you can use the
following keys:
Page - Please
You can also use calculations. If you are on page five and want to go to page two you could use the following keys:
Page - 3 Please
Related links
- [Minus] Command
Calculator Window
6.40. Move key
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
- key. If you press it twice it automatically take 10% off the value. So you
- key four times.
at -5
(execute command by pressing
At - (hold it while you type the value)
at - 5
(execute command by pressing
Please ).
Please ). An
5 Please , Holding the
161