MA lighting dot2 User Manual page 171
Control console
Hide thumbs
Also See for dot2:
- User manual (614 pages) ,
- Quick manual (67 pages) ,
- Getting started manual (3 pages)
Table of Contents
Advertisement
If you already have selected group five you can do this to add fixture two to your selection:
+
2 Please
Assigning values
The
+
key can be used to assign a value higher than the current value - Remember, you can't go above 100% on
the dimmer.
E.g. you have a selection of fixtures at a dimmer value of 50% and you want to raise it 20%. Here's what you type
(you have already selected the fixtures):
At
+
2 0 Please
That would do the trick.
There's a little extra function to the
could have archived the same by pressing the
Absolute value or relative value
The description above is about setting a relative value. You can also set an absolute positive value.
The difference between a relative or absolute value is a space between the plus sign and the number.
To set a relative value you could write in the command line
absolute value would be written
The positive value is usually implied unless you specify differently - so you just need to type
Using keys you can just press
+
(hold it while you type the value)
between the sign and the value.
Both will set the value at positive 5.
Using the calculator (you can get this by a short tap on the encoder for the value you want to set) you can tap
the +/- button to add the sign without a space. For relative values you can use the + button.
Page selection
You can use the
+
key to change the active page. If you want to go to the next page you can use the following
keys:
Page
+
Please
You can also use calculations. If you are on page two and want to go to page five you could use the following keys:
Page
+
3 Please
Related links
+ [Plus] Command
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
+
key. If you press it twice it automatically adds 10% to the value. So you
+
key four times.
at +5
(execute command by pressing
At 5 Please
. If you for some reason need to add the plus the you can press
5 Please
, Holding the plus while typing the value removes the space
at + 5
(execute command by pressing
Please
).
Please
). An
at 5
Please
.
At
171
Advertisement
Table of Contents
