MA lighting dot2 User Manual page 346

d o t 2 U s e r Ma n u a l
Start cue 1 of executor 2 gives you fixture 1 in red.
Fixture 2 and 3 are keeping the values from executor 1.
Figure 5: Fixture 1 red - fixture 2 and 3 blue
Example Cue Zero On - Copy with Status:
Let´s assume, you will copy cue 1 at cue 4 as it is and without tracking values from cue 3.
Turn cue zero on and choose copy method with status.
Copy Exec 1.2 Cue 1 At Exec 1.2 Cue 4
Cue 4 is exactly the same as cue 1 because it copies additional the values from cue zero.
Figure 6: Copied cue 1 to cue 4 with cue zero and status
Example Cue Zero On - Copy no Status:
Let´s assume, you copy cue 1 at cue 4 with cue zero on but with no status.
The values from cue 3 are tracked to cue 4.
Figure 7: Copied cue 1 to cue 4 with cue zero and no status
Off Time
To set the off time in seconds, use the plus or minus or the numbered keys on the console.
If an executor has an off time and you turn the executor off by using Off and pressing the executor button , the
executor turns off in the selected off time.
If an executor has an off time and you turn the executor off by using the fader , all attributes expect the dimmer turns
off in the selected off time, after you reached the 0% status of the fader.
chaser
If an executor is a and an off time is selected, the off time changes into an on and off time. The chasers
starts in the selected off time and ends in the selected off time.
Timecode
346
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com