MA lighting dot2 User Manual page 442

d) Press Prvw and press the actual
e) Press Prvw Exec 1 0 2 Please
The preview of executor 102 is visible in the
Hint:
To have a quick overview in the preview mode about different executors at the same time, press and
hold the Prvw key and press the different
Example 2
Let´s assume you will have a preview of cue 1 on the main executor without having an actual DMX output.
Requirement:
The main executor is off.
There are three ways to do this:
a) Press Prvw and tap at cue 1 in the
b) Press Prvw Cue 1 Please
c) Press Prvw Please .
The preview of cue 1 on the main executor is visible in the
Example 3
Let´s assume you will step thru the cue list on the main executor with cue timing and without having an actual DMX
output.
1. Open the main executor in the preview mode, press
Cue 1 on the main executor is in preview.
2. Press the small Go+ (=Go)
Cue 2 on the main executor is in preview with cue timing, e.g. fade.
Hint:
To go back from cue 2 to cue 1 in the preview mode use the small
Example 4
Let´s assume you will step thru the cue list stored on executor 2 without having actual DMX output.
1. Open executor 2 in the preview mode, press
Cue 1 of Executor 2 is in preview.
2. Press Prvw and then Next
Cue 2 of Executor 2 is in preview.
3. Repeat step 2 until you reach the end of the cue list.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
executor button of executor 102 on the console.
.
fixtures view without having a DMX output.
executor buttons
cues view of the main executor.
.
Prvw Please
Prvw .
Prvw and the executor button of executor 2
.
on the console.
fixtures view without having a DMX output.
.
Go- and Prvw on the console.
442